View Full Version : Phidget 1 servo controller & 12 v?

12-16-2007, 03:23 PM
I have a 12 v servo that I would like drive with a phidgets 1 servo controller. Is it possible to do so by hacking a usb cable's power wires and routing 12v through the board? It's looks as though the power goes through the chip.


12-16-2007, 05:27 PM
You don't want to get into hacking the USB cable. Besides, you'll fry the Phidget servo controller.

All you need is a Y splitter:


One end gets connected to a battery, one to the controller, and one to your servo. Just be sure to clip the power wire going to the controller itself.

12-17-2007, 12:13 AM
Ah, I see now it needs a common ground. I was bypassing the controller all together with power and ground. It works now. Thank you.