So, I've been working on PRS stuff again and finally to a place where it might be worth sharing and also so I do not forget ...again. The PRS (and maybe
Its been around 10 years since I purchased my Robonova-1, after playing around with it for while before a house purchase took over all my spare time.
The upcoming Robogames kicked me in the butt enough to dust off my Onyx X plans.
You may recall, I was too busy with the robomagellan last year,
For the fun of it and to do some experimentation, I put together a new Teensy board, that is the same size and has the same hole pattern as the Arbotix-Pro.
I just built a PhantomX with 18A servos and some the tibia servos are not being found while running the build check. I suspect not enough voltage is
This is a new transponder design for this year's RoboGames. You can also choose to use a older transponder from last year's RoboGames as
Just going to leave this here in case anyone else ever needs to turn a small PCB into a V-cut array. Would have made panelizing the quadnought power board
You're writing all that, and we don't get to see a picture? That counts as teasing :-)
It sounds like you're making progress, and by all means,
Mostly this hobby is tons of fun. Sometimes it's not...
Yes before I was using these little AMPS, I have played around with some different buzzer setups.
Most of them were copied
I tried to cut the new tibias with room for 1/2" steel balls today. It did NOT go well.
First, I found a bug in the Mach3 post processor
I, too, like sound feedback! Like Tician, I drive it with an N-channel MOSFET, and a 1k resistor, although I also add a reverse biased diode, for good
Solid: I thought it would be easier to solder. In hindsight I'm not sure it mattered. It does hold it's shape well...
Harness: Black (Ground),
Brooks, so your U-shaped wiring harness goes to to the Coxas and then regular daisy chain down each leg from there? You choose solid over stranded for
More like cooling actuators than cooling weapons.