I'm building some interface software between Processing and the ArmLink firmware and have sleuthed out what most everything does, but I can't figure out
I know I keep jumping around, but I am having some fun!
About a week or two ago, I purchased a Teensy 3.1 board as it looked like it could
Hi. I wanted to ask how I can create a service in intel edison? I need get processes that are currently running every 5 minutes, and if a sketch is not
Hi all, I have been reading for a while, but this is my first post.
I got interested in "Jimmy" when I saw some of the PR videos
Robogames 2016 is done and gone.... It was a lot of fun and I felt it went fairly well but its never too soon to start looking forward to next
So I'm seriously dedicating brain cycles towards a new Mech. I've got 18 servos on Numa, and I think some of them are probably bad. And I probably just
This sends a command to a particular destination to read back the register value.
However, you're not telling us which arm, and which servos, you're
Sorry, apparently an old version..
I also had to add the definition in the sound part in the Phoenix code too.
I needed something similar with an Edison project in the past. You can find my solution on github:
Sounds like you have made forward progress on your own. Indeed a good number of questions have been answered in other threads and with everything open
What library are you using here?
For example if you are using: https://github.com/KurtE/BioloidSerial/
Thanks to both of you for your fast reply!
I was just afraid to break something since I didn't understood all the parameters in:
Mechwarfare is now listed on the Robogames 2017 main Events page. If you click on the event it will drill down to the rules from 2010 which is out of
Hi Zenta, I have also not been very active lately as been busy with other things like working with the Teensy.
Yes Tician is correct and
T-3.5/3.6 are directly pin compatible for the pins that are available on the T-3.x, so probably just have to replace:
// Updates for Teensy...