Results 1 to 2 of 2

Thread: PWM Operating Mode

  1. PWM Operating Mode

    Hi there!

    I just detectet the PWM Operating Mode updating my MX-28 to (2.0).
    That is what I need, for spinning the strings of my marionett robot.

    • Can I wire the Dynamixel to the common servo 3-pin now?
    • I am using Showforge by Weigl, anybody with experinces in the room?

    Thanks for your supporting answers,

  2. #2

    Re: PWM Operating Mode

    No, the MX-28 has no way to be controlled by a RC-style PWM control signal.

    The "PWM control mode" simply means that you can set the duty cycle (and thus approximately voltage/current) of the motor H-bridge directly, without having the PID controller loop get in the way.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. News/Announcement PhantomX Pincher Arm - now supported with ROS Robot Operating System
    By corb555 in forum Interbotix Robotic Arms
    Replies: 3
    Last Post: 04-11-2018, 10:04 AM
  2. Question(s) Darwin 16-DOF operating with kinect, arduino, and hc-05 BT.
    By HadiShabara in forum DYNAMIXEL & Robot Actuators
    Replies: 13
    Last Post: 05-30-2016, 12:27 PM
  3. Question(s) Firgelli L-12/L-16 Continuous Operating Loads
    By fractura_laniatus in forum DYNAMIXEL & Robot Actuators
    Replies: 1
    Last Post: 05-18-2013, 10:55 AM
  4. What Operating System you guys use?
    By SuperMiguel in forum Robotics General Discussion
    Replies: 5
    Last Post: 10-16-2012, 09:55 PM
  5. Operating the Hitec 5990 TG with 8.4v peak?
    By AMOS in forum Robotics General Discussion
    Replies: 12
    Last Post: 07-27-2008, 05:11 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts