Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Dual VNH2SP30 assembly

  1. #11
    Join Date
    Apr 2013
    Geneva, CH
    Rep Power

    Re: Dual VNH2SP30 assembly

    Thanks jwatte for reminding me to keep it CW.

    Going on from what you said before regards testing, I in fact do not need to tie up precious pins setting INA1 to HIGH and INB1 to LOW, I can just tie them to 5v and GND. Setting PWM to 0 to stop firing.

    I could always have INA1 to a pin for high and low to switch between CW and brake to GND.


  2. #12

    Re: Dual VNH2SP30 assembly

    Or you could set PWM high and tie your PWM output to INA1 to fire (with pwm) or brake, with a single signal.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Re: Help in design to assembly
    By electronics in forum Mechanics / Construction
    Replies: 2
    Last Post: 05-30-2012, 06:05 PM
  2. Bioloid Premium Humanoid Assembly Instructions
    By california-ken in forum Humanoids, Walkers & Crawlers
    Replies: 0
    Last Post: 09-11-2011, 03:43 PM
  3. Bioloid Assembly Tip
    By Bushwhackr in forum Humanoids, Walkers & Crawlers
    Replies: 5
    Last Post: 05-25-2011, 03:06 PM
  4. Question(s) Phoenix Assembly
    By TaErog in forum Humanoids, Walkers & Crawlers
    Replies: 6
    Last Post: 06-04-2010, 11:26 PM
  5. How do I use the VNH2SP30 IC?
    By librab103 in forum Robotics General Discussion
    Replies: 2
    Last Post: 09-05-2008, 08:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts